Abaqus2Matlab v.3.0
A new way to post-process FEA

To see this working, head to your live site.

frankmail101

May 11, 2021

Nodal Displacement/Rotation and Coords - for Explicit

in Abaqus2Matlab Users Forum

Hello - I am trying to write to a .fil nodal displacements, rotations and nominal coordinates for a node set "SET" as per the below:

*FILE OUTPUT, NUMBER INTERVAL=100

*NODE FILE, NSET = SET

U,COORD

Then read into matlab viaAbaqus2Matlab. The displacements/rotations are in fact just for SET, but the coordinates are written for all nodes in the model. This is too much data. What am I doing wrong here?

8 comments

8 Comments

frankmail101

Aug 04, 2021

Thank you - I appreciate the guidance a lot - Best, Frank

bottom of page