Greetings,

I need some help in identifying and solving a problem with restart files. For a better understanding, the .inp files used are described below:

abaqus_rotation.inp = original file in which the necessary restart information is written.

abaqus_load.inp = original file that restarts from abaqus_rotation.inp.

abaqus_rotationtemp.inp = abaqus_rotation.inp edited with Abaqus2Matlab.

abaqus_loadtemp.inp = abaqus_load.inp edited with Abaqus2Matlab.

The editing is performed using tempAbaqusInpFile(inp_name), without any changes on the code.

The simulation runs perfectly using the following statement and the original files:

abaqus_simulation = system(['abaqus job=abaqus_load.inp oldjob=abaqus_rotation cpus=4 interactive'])

However, the simulation does not run and the following message appears when I replace the job and/or the oldjob with the edited files.

If possible, could you help in solving this problem? I don't know why, but I can't upload the files here... If necessary, I can send them by e-mail.